I recently stumbled across this (seemingly new) forum for Stratasys users. Check it out at http://stratasysusers.org/
email me at firstname.lastname@example.org i can make it run again.
I have a BST 768 . Nova 600 R2 board hit by lightning . Can not get Realtek Phy chip . Replacement pcb US$ 2975.00 !!!!!!
Wired up monitor , mouse , kbd . Booted into Linux root , set up PPP link via serial port ttyS1 to Windows PC . Can ping between printer and PC , but when I run Catalyst and try to edit the ip Address to that of the PPP ip it crashes with ” cannot retrieve lock file ” .
Has anyone connected to the Dimension printer via serial port running PPPD . I am using the correct serial port and not the diagnostic one that connects to the stepper driver card .
Your email address will not be published.